INSTALLATION BRACKETS
The brackets provided are used for all types of installations, outside, ceiling and inside.

Note: Two screws are supplied for each bracket. These screws have Phillips hex heads, suitable for wood or sheet metal mounting surfaces. For PLASTER, DRYWALL, CONCRETE, STONE, BRICK OR TILE installations, we recommend using plugs or anchors.

MOUNTING THE BRACKETS
Make certain brackets are mounted straight and even or shade will roll crooked.

CHOOSE ROLL DIRECTION
Beaded Chain Control Shade ; For regular roll, mount clutch bracket on the right, end plug bracket on the left.

Spring Shade : For  regular roll mount round pin bracket on the right, slotted bracket on the left.

Regular Roll

Reverse Roll

INSTALL SHADE

Beaded Chain Control Shade

Push the clutch straight on to the blade of its bracket. The bottom of the clutch should always point straight down, as shown here.

Lower the lug of the end plug onto the V of its bracket. The roller should fit into the brackets securely, with just a little play.

Spring Roller Shade

Always put the slotted end in the bracket first.

Insert the round pin end.

SHADE OPERATION

Beaded Chain Control Shade

Pulling gently on the loop in one direction raises the shade; pulling the chain in the other direction lowers the shade.

Spring Roller Shade

Always pull shade from the center. To lower shade, gently pull the shade and slowly release but do not let go until shade springs into locked position. To raise shade, gently pull the shade until spring lock is released and guide the shade to the desired position.